Jam

The jam code comes back after the paper is out

Office printers and MFPs

Clear the sheet you can see, then look for the piece you cannot. Most repeat jams are a torn corner still sitting on a roller or against a sensor flag. Open every door the panel names, including the one behind the right-hand cover if the diagram shows it.

Fan the stack. Paper that was sliced from a ream and left in a damp room sticks together and feeds two sheets. Set the side guides so they touch the stack without bowing it. Do not fill a tray past the line molded into the plastic.

If the code names a tray and that tray is empty, a small plastic flag may be stuck down. Do not snap it back and forth until it breaks. That is a visit. Write down the exact code, the tray number, and whether the sheet came out whole or in pieces.

The fuser is the hot assembly the paper passes through last. Right after a job it can burn skin. If the panel sends you there, wait until the machine has been idle and cool, or leave it for the technician. Do not tape a door switch closed to “see what happens.”

Open a ticket for this